制造厂数据报告NB注册要求
技术交流 | 2018-07-23
在NB官网（The National Board of Boiler and Pressure Vessel Inspectors）上留意到有关钢印产品NB注册的最新要求，在此提供给诸位，以作参考：
Registration of an item with the National Board involves the manufacturer submitting an original manufacturer’s data report to the National Board for permanent retention. Registration is more than record retention; it represents the culmination of a three-step process, including the design and construction of an item in accordance with the American Society of Mechanical Engineers Boiler and Pressure Vessel Code (ASME BPV Code), the inspection by a National Board commissioned inspector, and the final documentation certifying compliance with the ASME BPV Code.
Any manufacturer meeting the requirements of NB-264, Criteria for Registration may become authorized to register. There is no charge to become authorized to register, but there is a fee for each item registered.
Manufacturers may register printed original data reports or may set up a National Board Electronic Data Transfer (EDT) account and register items electronically.
A Brief History of National Board Registration is included for reference.
A listing of manufacturers and repair organizations authorized to register is presented in a searchable format in the Manufacturer & Repair Directory.
ASME BPV Code / National Board Inspection Code (NBIC) Data Report Forms Revisions
The 2017 revisions to the ASME BPV Code and NBIC data report forms became mandatory on January 1,2018（明确规范和数据报告表格版本的正确使用）. Items manufactured/altered/repaired to the 2017 codes must be documented on the current forms.
All data report forms submitted to The National Board for registration on outdated forms will be returned for correction.
提交NB注册的数据报告还必须满足以下要求：
1. Data report forms must be in the exact format and have the same content as those found in the ASME BPV Code and the NBIC.
2. Two-sided data report forms (BPV Section IV forms - the second page says “Back”) must be submitted as such. It is not acceptable to submit these data report forms on two separate pages. （注意你所使用的数据报告表格是否要求内容必须显示在正反面上的，如果是，那不允许分开放在单独的两页上体现）
3. The header must be completed on each page of data report forms that will be submitted on multiple pages (Ex. U-1, U-2, P-3). There must also be space for the company representative and authorized inspector to initial each page.
（要求制造厂代表和AI在每页签字）
4. All data report forms and their content must comply with The National Board’s font size requirements. The National Board requires the use of at least a 6 point font size in creating data report forms and at least an 8 point font size on any technical information provided on the data report form (Arial 8 or comparable size in any other font style). The only exception to this will be in sections which have a table format (example: heads and nozzles). In these sections, a 7 point font will be acceptable if the data remains legible.（数据报告字体的要求）
5. Data report forms, including all attachments (supplemental sheets and partial data report forms), submitted for registration must be legible. The legibility of data reports is subject to review/acceptance by The National Board staff.
本文系网络转载，如涉及作品版权问题，请与我们联系
400-101-0869
